Product Details

Product Details

Input Power Supply

5V 2A


100 LM

Output power supply

5 V


Slide or touch to turn on and off

Light Source


Size of the product

(L x W x H)

4.1 x 3.5 x1.2 IN

10.3 x 9 x 3 CM

Power Consumption

0.5 W

Length of USB cable

5 feet/ 1.5 Meters


  1. Please only use a high-quality adapter (Output 5V 2A) or the lights will not work properly
  2. Do not connect more than eighteen (18) lights
  3. The center of the light tile responds best to the touch function

Installation Instructions

  1. Place all lights face-down. Incert PCB Boards to connect the lights. Build a design shape of your choice. Keep the side of the USB board with 2 smaller arrows in the same side of the face of the light. 
  2. Snap in the triangle Connectors on some corners of the lights to keep the unit sturdy
  3. Insert the USB cable into the adapter. Find the USB port on the light closest to the desired wall outlet.Connect the other end of the USB cable to the closest LED touch tile. Plug the Adapter into the wall outlet.
  4. Make sure every light works. Try using different PCB boards if any lights don’t work.
  5. Unplug the adapter, then place the lights face down on a flat surface. Peel the paper from the double sided adhesive and paste one side in the circled back on the lights.
  6. Find a place to display the lights. After cleaning and drying the area, press the adhesive tape to the wall. (Note. The PCB boards are strong enough to further support the lights on a Hook, Nail or Screw *not included)
  7. Plug the Adapter back to the wall outlet. Slide the center of the lights to individually turn on or turn off the lights to customise your glow.

Free USB ports on the lights can be used to charge other devices. Please DON’T supply power to any other device while all the lights are lighted.If ever there are questions about proper electrical usage, consult a licensed technician.